HGM PIPE

[stevendellady]

HI BRO'S, I JUST WANT TO HEAR FROM YOU ADVICES OR SUGGESTIONS ABOUT WHAT HAPPEN TO MY SNIPY...YESTERDAY I BOUGHT HGM PIPE, AFTER INSTALLATION, I TEST DRIVE..BUT I SHOCKED BECAUSE TOP SPEED WAS DECREASED COMPARE TO THE STOCK EXHAUST. BEFORE, MY TOP SPEED IS ABOUT 110K/H, BUT NOW ITS ONLY 1OOK/H FULL THROTLE...GUYS WHAT SHOULD I DO?..PLS HELP TNX

 

[chat_master08]

dont depend on the speed displayed on the speedometer... coz its not accurate.. tune the bike up.. then see if it'll not improve..

 

[dopydop]

you need a bigger carb jettings. like 107.5 or 110. its because there is no back pressure but ur acceleration increased ryt?

 

[X Project]

HI BRO'S, I JUST WANT TO HEAR FROM YOU ADVICES OR SUGGESTIONS ABOUT WHAT HAPPEN TO MY SNIPY...YESTERDAY I BOUGHT HGM PIPE, AFTER INSTALLATION, I TEST DRIVE..BUT I SHOCKED BECAUSE TOP SPEED WAS DECREASED COMPARE TO THE STOCK EXHAUST. BEFORE, MY TOP SPEED IS ABOUT 110K/H, BUT NOW ITS ONLY 1OOK/H FULL THROTLE...GUYS WHAT SHOULD I DO?..PLS HELP TNX

Hey bro, if you changed the pipe and only the pipe and did not made any changes on the carb settings, try to check the o-ring on the exhaust port if it is there or if the nuts are tightened decently otherwise the exhaust fumes might be sneakin out between the ex port and pipe manifold... This is one of the few necessary evils that could cause that kind of problem... You sure you just changed the pipe without touching anythin aside from it? If it does'nt resolve the issue then it's time for you to call me so I can provide assistance through mobile phone as you're way too far from where I am located... 0922-895-0069

 

[traxxas-modifier]

nice tip xproject.

rejetting also helps.
check the for sale section for jet kits.

i will try to find exhaust gasket, my exhaust gasket is also
worn out...

 

[JUNEX]

btw, when will i change my jett kits? im only 1500k in odo reading

 

[Mas Catoer]

Sorry for asking. is it free flow one?
The same thing happened to me. losing the power drastically.
If not doing jetting, the pipe need inner mods so the exhaust is not too free to flow.
Then gain the power back.

 

[traxxas-modifier]

@junex

jettings will only need be done only if you have free flow exhaust pipe.
if youre using stock, you can rejet to #105 which is the jet used by AC sniper.

 

[Henry]

HELLO ALL... WHERE CAN I GET THE HGM PIPES AND HOW MUCH DOES IT COST?

 

[rhoitol]

HGM pipes made in Bulacan. phil..I also used HGM pipe.the pipe is kinda delay,why?because the elbow is small in raduis,my friend from San Miguel,Bulacan,whose working in shop there(as a mechanic )..He want me to change with 4N pipe..more power in acceleration,unlike hgm pipe..Gudluck bro..

 

[cho]

Sir rhoi, how much does 4n pipe will cost?!... bec. i want to buy that pipe too.

 

[beneer]

hello Bros, i have my HGM pipe.. so as that, my prolem is, it decreases the speed of my snify... unlike of that stock pipe, i made all the timings, gasket change, etc... but it still the same speed...

 

[rhoitol]

sir cho..it depends on the design..but the flower type..P 3500 to 3700..u can purchase either in caloocan or go direct to Baliuag,Bulacan..Maybe next month,i will change mine to 4n pipe.Hope this help.

 

[cho]

4n & DBS pipe... which pipe do u prefer will give more power?!

 

[rhoitol]

i will prefer 4n pipe.

 

[target]

sirs, is 4n pipe really give more power, or they called "may lakas pag dumudulo?"

 

[target]

sirs, i assure you, go with 4n pipe.. much better than HGM

 

[rhoitol]

4n pipe is the best..